Remington 700 Rifle Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
My Tactical 308 has a tendency to not feed the round every so often. It seems that the bolt just isn't catching the next round. Any ideas of what I could do? Is it a problem with the feeder spring?
 

·
Registered
Joined
·
173 Posts
It's a semi common problem.. when it fails to feed look inside and see how the round is sitting. The rear of the round can sit too low thanks to the feed lips. You'll also notice scratching on the sides of the cases from it. Just take a little fine grit sandpaper and slowly sand, check, and recheck. I had the same problem when I got mine.
 

·
Registered
Joined
·
477 Posts
that happens to me too, no worries there, just clean it after you're done shooting. i take apart the bolt every now and then and make sure there's none inside it.
 
1 - 5 of 5 Posts
Top