Remington 700 Rifle Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Here are some pictures of my 6.8 that I built.

The lower is a CMT (Stag).
Trigger is a Chip McCormick Super Match single stage.
With a Ergo sure grip.

Upper was a stripped one I picked up at a gun show a long time ago. And I don't know who the
Mfg. is but it functions fine.
The barrel is a DPMS 16" 1:10 twist
Gas block is a Yankee Hill Machine with flip up sight tower.

Scope is a Millett DMS-1. 1-4x24
On a Burris 30mm mount.

This is a pic with the old scope rings before I got the Burris mount.



 

·
Registered
Joined
·
2,799 Posts
SPC II chamber ? if not there is a reamer going around 68forum.com that you can convert it to SPC II and us hotter loads. With 115 SMK's I was pushing 2600 + FPS which is really good for a 6.8 SPC.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 ·
No I have not done the chamber. I use liter loads close to one of the ones you posted in your range report. I'll post my loads over on that thread.
 
1 - 5 of 5 Posts
Top